Hilti DX 6 Mode D'emploi page 10

Masquer les pouces Voir aussi pour DX 6:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

1.3
Product-dependent symbols
1.3.1
Symbols
The following symbols are also used:
If applied on the product, the product has been certified by this certification body for the US and
Canadian markets according to the applicable standards.
1.3.2
Obligation symbols
The following obligation symbols are used on the product:
Warning! Observe the instructions.
Wear a hard hat
Wear eye protection
Wear ear protection
1.3.3
Information shown on the display
The following information may be shown on the display:
This symbol indicates the battery's state of charge. When the battery is empty, the maintenance
symbol appears.
The "maintenance" symbol indicates that maintenance is due. It appears after 5 years, when
30,000 fasteners have been driven, or when the battery is empty. Our recommendation: Consult
Hilti Service.
The "fasteners driven" counter indicates when the next service is due. One segment stands for
500 fasteners driven. There are 5 segments in total, representing 2,500 fasteners driven.
This symbol indicates whether Bluetooth is switched on. If the symbol is not shown on the display
then Bluetooth is switched off.
1.4
Product information
products are designed for professional users and only trained, authorized personnel are
permitted to operate, service and maintain the products. This personnel must be specifically informed about
the possible hazards. The product and its ancillary equipment can present hazards if used incorrectly by
untrained personnel or if used not in accordance with the intended use.
The type designation and serial number are printed on the rating plate.
▶ Write down the serial number in the table below. You will be required to state the product details when
contacting Hilti Service or your local Hilti organization to inquire about the product.
Product information
Fastening tool
Generation
Serial no.
2
Safety
2.1
Safety instructions for powder-actuated direct fastening tools
▶ Do not tamper with or modify the fastening tool in any way.
▶ Use only fastening tools and items of equipment that are compatible with each other (base plates,
fastener guides, magazines, pistons and fasteners) and consumables (fasteners and cartridges).
2
English
DX 6
01
2232123
*2232123*

Publicité

Table des Matières
loading

Table des Matières