Wolf Garten LYCOS E/280 T Notice D'instruction D'origine page 19

Safety information
If the mains cable of this device is damaged,
it must be replaced by the manufacturer, its
customer service or a quali ed person in
order to avoid hazards.
Never bypass or remove safety devices
installed on the device (e.g. by taping the
push-button to the handle).
Do not push the line box into the ground
or hit it against wall edges. If the line box
suddenly receives a heavy blow, be prepared
for increased vibration at the handle. If this
does occur, the device must be checked and,
if necessary, repaired by a quali ed expert or
workshop.
Under the following circumstances, switch
the device o and remove the mains plug
from the power supply. Make sure that all
moving parts have come to a complete
standstill:
- Before you leave the device;
- Before you release a block;
- Before you conduct cleaning, maintenance and
tuning tasks;
- Before you check the device for damage; e.g.
after a foreign object has been encountered;
- If the device is vibrating excessively heavily.
After use
Switch the device o , pull out the mains plug
and check the device for damage. Attention,
danger! Cutting tool still running!
If you need to clean or service the device,
switch it o and pull out the mains plug.
Always wait until the cutting tool comes to a
standstill.
Removal of guards or replacement of the line
spool must only be performed if the motor is
stopped and the cutting tool switched o and
then only if the mains plug has been pulled
out. Use only an original line spool and observe
the tting instructions!
Ensure that ventilation slots are free from dirt.
Do not clean the device with water.
Store the device in a secure location.
Store the device out of reach of children.
Do not repair the device yourself; it must be
repaired by a quali ed expert or workshop.
Allow the motor to cool before putting the
device away.
Safety information
General safety information
Spare parts must meet the requirements of
the manufacturer. Therefore, use only original
spare parts or those spare parts authorised by
the manufacturer. When replacing spare parts,
always observe the supplied tting instructions,
always pull out the mains plug rst.
Repairs must only be performed by a quali ed
technician or service centre. Specialist
workshop addresses can be found on our
website.
This trimmer is intended for the care of lawn
edges and smaller grass and lawn areas in
private households. The device must not be
used for purposes other than those intended
because of the risk of bodily injury to the user or
other persons.
Only use the trimmer in daylight or under
bright arti cial light. Keep your work area clean
and well lit.
Only use the trimmer in dry weather
conditions. Keep it away from rain or damp. The
ingress of water into the trimmer increases the
risk of an electric shock.
Do not use the device if it is raining or there is
a risk of storms.
Even if all safety and operating instructions
are heeded, there is always a residual risk of
injury and property damage. Always bear this
in mind.
Replace all worn or damaged information
signs on the device.
EN
19