Table of Contents
Safety........................................................................2
Specifications...........................................................2
Work Area.................................................................3
Service.....................................................................4
Inspection.................................................................4
Operation.................................................................4
To Convert Gun..........................................................6
French Version...................................................10-17
Safety
Read and carefully observe these operating instruc-
tions before unpacking and operating PowerLuber.
Operate PowerLuber only after safety instructions
and this operation manual are fully understood.
Never operate PowerLuber in explosive atmo-
sphere. Electric power tools can create sparks
which may ignite flammable liquids, dust or fumes.
Do not use battery charger in damp or wet loca-
tions.
Grease gun can develop high pressure - up to
6,000 PSI (413 Bar). Use safety glasses and
gloves for protection during operation. Keep
hands clear of the exposed rubber portion of hose.
Extreme pressure may cause nozzle extension or
whip hose to burst. Use only Lincoln APPROVED
hoses and follow whip hose instructions and
warnings.
General Description
The Lincoln PowerLuber is a fully battery operation-
al, automatic grease gun. The gun was developed
for manual lubrication of the grease points and
includes a pressure relief valve to relieve excessive
pressure (6000 PSI or 413 Bar) in the case of a
blocked bearing, fitting or lubrication line.
Page Number - 2
The PowerLuber is driven by a small, low voltage
electric motor connected to a three-stage planetary
gear reducer. The rotary motion of the motor is
converted into a reciprocating motion of the plunger
through an eccentric and yoke mechanism. The
PowerLuber is a positive displacement single acting
pump.
Appropriate use
The PowerLuber was exclusively designed to pump
and dispense lubricant using 12 volt battery power.
The maximum specification ratings should not be
exceeded.
Any other use not in accordance with instructions will
result in loss of claim for warranty or liability.
MODELS AND COMPONENTS
Sales
Basic Power-
Model
Luber
1240
1200
1242
1200
1244
1200
1242E
1200
1244E
1200
Specifications
Basic PowerLuber Model 1200
Operating Power, Volt
Maximum Operating Pressure, PSIG (bar) 6,000 (413)
Grease Reservoir Capacity, oz. (cm³)
Operating Temperature Range, °F (°C)
(-18 to +50)
Operating Current, AMP
(at 1,000 PSIG (69 bar)
Lubricant (Grease)
Grease output oz./min. (cm³/min)
at 1000psi (69bar)
Weight, Lbs. (Kg)
Accessories:
Battery Model 1201
Output, VDC
Capacity, mAh
Battery Charger
Charge time
Output, VDC, (1.7A)
Model 1210
Input, VAC (650mA)
Model 1210E (for use in Europe)
Input, VAC, (350mA)
Outlet Hose Model 1230
Pressure Rating, psi(Bar)
Length of the Hose, In (mm)
Battery Charger Case
1201
1210
1201
1210
1201 (2)
1210
1201
1210E
1201 (2)
1210E
12
14.5 (450)
0 to 120
4
Up to NLGI #2
2.6 (76.3)
8.2 (3.76)
12
1300
1 Hour
14.5
120 V, 60 Hz
220 V, 50 Hz
7,500 (510)
30 (760)
Form 422014
------
1202
1202
1202
1202