Intended Use; Limitations Of Use - Dräger REGARD 3000 Mode D'emploi

System components
REGARD 3000 Display Unit, black
REGARD 3000 Base Unit, grey
REGARD 3000 Base Unit, black
4-20 mA Input Module / HART 2 Ch
4-20 mA Input Module / HART 4 Ch
Relay Module 4 Ch
Relay Module 8 Ch
Modbus RTU Gateway Module
Slotcover
REGARD Configuration Software
REGARD 3000/5000 PC-Software Key
REGARD 3000 Docking Station SP
REGARD 3000 Cabinet Wire Harness 2 m 37 04 261
REGARD 3000 Retaining Clip
Adapter plate
In the event of an extension with modules, Dräger recommends first updating the
display unit firmware. The latest firmware can be downloaded from the
ServiceConnect
the latest firmware is not used, there is the possibility that some features of the new
modules may not be supported.
3.4

Intended use

REGARD 3000 is a modular controller for gas detection and fire alarm systems.
The system continuously monitors production facilities for the following conditions:
– Presence of gas and/or vapour concentrations in the ambient air
– Outbreak of fire
The system has the following functions:
– Power supply of the connected transmitters and sensors
– Evaluation of all measurement and status signals
– Actuation of the associated alarm devices
All measured values and important system parameters can be continuously
displayed on a Display Unit and sent to primary control centres via a Gateway
module.
3.5

Limitations of use

REGARD 3000 is not designed for use in process control.
The REGARD 3000 network may only be used for REGARD 3000 communication.
For example, connection with a general IT network is prohibited.
|
Instructions for use
REGARD 3000
®
web portal (www.serviceconnect.draeger.com) free of charge. If
System overview
Order number Software /
Firmware version
37 09 719 01.00.xx
37 06 357 N/A
37 05 684 N/A
37 05 680 01.01.xx
37 05 681 01.01.xx
37 05 687 01.00.xx
37 05 688 01.00.xx
37 05 693 01.00.xx
37 05 672 N/A
N/A ≥01.04.xx
37 09 533 N/A
37 09 678 N/A
N/A
37 20 165 N/A
37 11 953 N/A
|
en
103