Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
5. Install the plate with the flange facing
the wall, inside the motor casing: carry
out the instructions at stage 3 in re-
verse order then use the screws provi-
ded to complete installation. (Tot. 12).
(Note! If air is discharged from the top,
rotate the plate and install it in the op-
posite direction with the flange facing
upwards) Fig.5
6. Put the top cover back on.
7. Open the flap Fig.6
8. With the aid of a slotted screwdriver,
break the grommet of circular hole
through which the wires pass. Fig. 7
9. Insert the female connector in the
terminal box already attached to the
hood. Fig. 8A
- 15 -
Publicité
Chapitres
Table des Matières
