Gaggenau RF 240 Notice D'utilisation Et De Montage page 36

16
16
10. Place the covers (16) into the mounting angle at the
top and bottom (17).
11. Secure the mounting angle (17) at the top and
bottom using the screws (19). Do not tighten the
screws completely. The mounting angle (17) must
still be able to move to the left and right.
12. Remove the protective foil from the cover strip (20).
13. Position the handle side of the cover strip (20) flush
mounted on the lug of the upper cover (16) and stick
it to the side wall of the appliance.
14. Shorten the cover strip (20) at the bottom if required.
The cover strip (20) must end 3 mm above the upper
edge of the lower mounting angle (17).
15. Slide the appliance into the recess until the covers
(16) butt against the side wall of the kitchen unit.
36
17
19
16. If the kitchen unit walls are 16 mm thick:
Allow the spacers (14) to butt against the side wall of
the kitchen unit.
17
17. If the kitchen unit walls are 19 mm thick:
Align the front edges of the hinges flush with the
side wall of the kitchen unit.
18. In the case of kitchen units (16 mm and 19 mm)
with door jamb parts (knobs, sealing lips, etc.):
Bear in mind the installation dimension (depth of the
door jamb parts): Allow hinges and covers (16) to
project from the installation dimension.
20
19. Set up the appliance in an upright position by means
of the threaded feet using the enclosed open ended
spanner (21).
14
21