EINHELL ROYAL ERT 300/1 Mode D'emploi page 11

Anleitung ERT 300-1:AnleitungERT 300_SPK7
Within the working radius of the grass trimmer
the user is responsible for any damage caused
to third persons by use of the trimmer.
Never cross roads or pebble paths with the grass
trimmer switched on.
When you are not using the grass trimmer, keep
it in a dry place out of the reach of children.
Use the grass trimmer only as described in these
directions for use and always hold it vertical to
the ground. All other positions are dangerous.
Check the screws regularly to see that they are
properly tightened.
The mains voltage must be the same as the
voltage specified on the rating plate.
Check the power cable regularly for signs of
damage or aging. Never use the grass trimmer if
the power cable is in less than perfect condition.
Power cables used with the trimmer must not be
of a lighter duty class than HO7RN-F rubber-
insulated flexible cables according to DIN 57282
/ VDE 0282 with a minimum diameter of 1.5 mm
Plug connectors must be equipped with earthing
contacts and the coupling must be rain-water-
protected.
Keep cables and other objects out of the area
you want to cut.
If you have to lift the grass trimmer to move it,
switch off the motor and wait for the rotating tool
to stop. Before you leave the trimmer, switch off
the motor and pull out the power plug.
Before you connect the grass trimmer to the
power supply, make sure that none of its moving
parts are damaged and that the line spool is
correctly inserted and fastened.
Never cut against hard objects when using the
grass trimmer. This is imperative to avoid
causing injury to the user and damage to the
trimmer.
Use only original replacement parts for repair
and maintenance purposes.
Have repairs carried out only by a qualified
electrician.
Examine the grass trimmer for signs of wear or
damage each time before you use it and after
any collisions. Have essential repairs carried out
without delay.
Always keep your hands and feet away from the
cutting mechanism, particularly when you switch
on the trimmer.
After pulling out new line, always return the
trimmer to normal working position before you
switch it on again.
Never use replacement parts or accessories
which are not foreseen or recommended by the
manufacturer.
Pull out the power plug before carrying out any
29.11.2006
inspection, cleaning or other work on the trimmer
and whenever it is not being used.
Caution! The nylon line will run on for a few
seconds after the tool is switched off!
3. Explanation of the warning notice
(see Figure 2) on the grass trimmer
1: Caution!
2: Wear safety goggles!
2 .
3: Protect from the damp!
4: Read the directions for use before putting into
operation for the first time!
5: Pull out the power plug before checking if a
connecting lead is damaged!
6: Keep third parties away from the danger zone!
7: The tool runs on after being switched off
4. Technical data
Voltage: 230 V ~ 50 Hz
Power rating:
Cutting width:
Revolutions n :
0
Nylon cutting line:
Sound pressure level L :
pA
Sound power level L :
WA
Vibration a
hv
The noise level of this machine may exceed 85
dB(A). In this case, noise protection measures need
to be introduced for the user. The machineʼs noise
was measured in accordance with EN 786. The level
of vibrations emitted from the handle is ≤ 2,5 m/s
Measurements were taken in accordance with EN
786.
7:33 Uhr Seite 11
GB
275 W
200 mm
13000 min
-1
Ø 1.3 mm
74,8 dB
94,8 dB
2,5 m/s 2
2 .
11