Connecting The Audio Cables; Connecting/Disconnecting The Kh 120 To/From The Mains Power Supply - Neumann.Berlin KH 120 Manuel Utilisateur

Connecting
XLR cables
Connecting
unbalanced cables
EN
8 | KH 120

Connecting the audio cables

Connecting analog cables
Connect the left and right output of your audio source to the XLR sockets of the respective
loudspeaker.
XLR
Right signal
Use an XLR adapter (not supplied) to connect unbalanced cables (e.g. RCA cables).
Use the following wiring if you want to make your own XLR adapter:
Wiring
Source (RC Source (RCA)
Connecting/disconnecting the KH 120 to/from
the mains power supply
To connect the KH 120 to the mains power supply:
Make sure that the on/off switch 3 is set to "OFF".
Connect the IEC connector of the supplied mains cable to the mains socket 4.
4
3
Power Source
Connect the mains plug of the mains cable to a suitable wall socket.
To disconnect the KH 120 from the mains power supply:
Set the on/off switch 3 to "OFF".
Pull the mains plug out of the wall socket.
XLR
Left signal
Analog Source
Pin Signal
1 Audio ground
Loudspeaker (XLR-M) dspeaker (XLR-
2 Signal +
3 Signal −