Installation; Box Contents - Planika Faro KF 22 Installation Et Manuel D'utilisation

•
Leaks should be found with the use of a cleaning liquid and water. If bubbles form on the surface that means
that a there's an existing leak.
•
Always use a pressure regulator between the gas bottle and the device. Replace the pressure regulator every
5 years. The allowed pressures are: 30mbar, 37mbar (recommended), 50 mbar. Use only regulators complying
with the European EN16129 Norm.
•
Use only approved and certified gas connection linkage. Replace the linkage every 2 years.
•
Check the flexible hose at least once per month and each time the cylinder is changed. If it shows signs of
cracking, splitting or other deterioration it shall be exchanged for new hose of the same length and of the
equivalent quality.
•
Do not connect the gas cylinder directly to the appliance without regulator.
•
The tubing or the flexible hose must be changed within the prescribed intervals.
•
Use only the type of gas and the type of cylinder specified in these instructions.
•
The elastic linkage connecting gas to the fireplace is to be led away from sharp edges and hot surfaces. Refrain
from bends and twists of the elastic connection on its full length.
•
Remember that the LPG bottle should be stored in a well-ventilated place. LPG gas is heavier than air and its
accumulation near the bottom surface may generate an explosive mixture.
•
The gas cylinder needs to be shut if the fireplace is not being used.
•
Filling the gas cylinders is to be commissioned to certified gas filling stations.
•
Replacement of empty cylinders for full ones is to be conducted only in authorised locations.
3.

INSTALLATION

3.1. Box contents

•
1x complete FARO fireplace
•
4x Tempered glass screens
•
1x bag of decorative stones
•
4x Wheels
•
1x AAA battery
•
1x 1,4 metre flexible hose Ø9mm – installed
•
1x pressure regulator (37mbar) – installed
•
1x Wrench
•
1x installation manual and user's manual
6