Installation; Important Installation Instructions - LiftMaster Elite Serie Manuel D'installation

IMPORTANT INSTALLATION INSTRUCTIONS

TO REDUCE THE RISK OF SEVERE INJURY OR DEATH:
1. READ AND FOLLOW ALL INSTRUCTIONS.
2. Install operator ONLY on properly balanced and lubricated gate/
door. An improperly balanced gate/door may NOT reverse when
required and could result in SEVERE INJURY or DEATH.
3. ALL repairs to cables, spring assemblies and other hardware
MUST be made by a trained systems technician BEFORE installing
operator.
4. Disable ALL locks and remove ALL ropes connected to gate/door
BEFORE installing operator to avoid entanglement.
5. Install gate/door operator 8 feet (2.4 m) or more above floor.
6. NEVER connect operator to power source until instructed to do so.
7. Any openings shall be designed, guarded or screened to prevent a
4" (10.2 cm) diameter sphere from passing through the openings
anywhere in the gate/door.
8. Entrapment protection devices MUST be installed to protect anyone
who may come near a moving gate/door. Upon completion of
installation, test entrapment protection device.
9. Too much force on gate/door will interfere with proper operation
of safety reversal system.
NEVER increase force beyond minimum amount required to
l
move gate/door.
NEVER use force adjustments to compensate for a binding or
l
sticking gate/door.
If one control (force or travel limits) is adjusted, the other
l
control may also need adjustment.
ALWAYS wear protective gloves and eye protection when changing the battery or working around the battery compartment.
l
NEVER wear watches, rings or loose clothing while installing or servicing operator. They could be caught in gate/door or operator mechanisms.
l

INSTALLATION

10. Install control station:
within sight of the gate/door
l
out of reach of small children at a minimum height of 5 feet
l
(1.5 m) above floors, landings, steps or any other adjacent
walking surface.
at least 6 feet (1.8 m) from the gate/door or ANY moving part of
l
the gate/door
11. This operator is intended for vehicular use ONLY. To prevent
INJURY to pedestrians, a separate pedestrian access should be
supplied, visible from the gate/door. Locate the pedestrian access
where there is NOT a chance of INJURY at ANY point during full
movement of the gate/door.
12. Install Warning signs on EACH side of gate/door in PLAIN VIEW.
Install one Warning Sign next to the control station. Permanently
secure each Warning sign in a suitable manner using fastening
holes.
SAVE THESE INSTRUCTIONS.
13.
9