Dimplex HPL 9S-TUW2 Instructions D'installation Et D'utilisation page 25

Pompe à chaleur air-eau pour installation extérieure avec tour hydraulique combinée

Masquer les pouces

Les langues disponibles

HPL 9S-TUW2

Complies with the European safety regulations

Additional model features

8.1

Type of defrosting

8.2

Frost protection, condensate tray /

Water in device protected against freezing

8.3

Maximum operating pressure (heat sink)

8.4

Energy efficiency class / energy efficiency (low temperature)

8.5

Energy efficiency class / energy efficiency (mean temperature)

Heat output COP

9.1

Heat output / COP

1. For air temperatures between -22°C and -5°C, flow temperature increasing from 45? to 60?.

2. These data indicate the size and capacity of the system according to EN 14511. For an analysis of the economic and energy efficiency of the system, other parameters, in particular

the defrosting capacity and regulation, should also be taken into consideration. These figures are only achieved with clean heat exchangers. Instructions for care, commissioning

and operation can be found in the relevant sections of the installation and operation instructions. The specified values have the following meaning, e.g. A7/W35: outside air tem-

perature 7 °C and heating water flow temperature 35 °C.

3. Standard nominal flow only possible with an electronically controlled circulating pump with actuation via heat pump manager.

4. The heat output and COP is reduced by approx. 5 % in lower operation

5. The maximum sound power level under full load can increase by up to 5 dB(A).

6. The specified sound pressure level represents the free sound area level. The measured value can deviate by up to 16 dB(A), depending on the installation location.

7. See CE declaration of conformity

8. The heat circulating pump and the heat pump manager must always be ready for operation.

www.gdts.one

Performance level

at A-7 / W35

at A2 / W35

at A7 / W35

at A7 / W45

at A7 / W55

at A10 / W35

452168.66.11 · FD 9908

bar