Kuppersbusch EWK880-0-2Z Mode D'emploi page 18

Changing the door hinge
Reversible door for EWK880-0-2Z
Your wine refrigerator is fitted with a reversible door.
Please follow the procedure below to change the opening direction:
1. Switch off the appliance before carrying out any work on it by
pulling the mains cable out of the power supply socket.
2. Please note:
3. Keep all the parts you remove in a safe place for remounting the
door.
4. Remove the glass door by unscrewing the eight lock screws 3
and 4. Be careful to hold the glass door firmly after removing the
screws and place it on a padded surface to avoid the risk of
damage.
5. Unscrew and transfer the door supporter 2 to the opposite side.
6. Rotate the glass door 180° and refit the glass door to the
opposite side. Then screw and tighten it after the door is leveled.
Reversible door for UWK8200-1-2Z
1. Reassembly the ventilation grilles. Remove the ventilation grille
○,2 and the adjustable ventilation grille ○,1 by unscrewing the
screws ○,3 & ○,4. (Fig. 1)
2. Remove the bottom hinge ○,5 by unscrewing the four lock
screws ○,6. Be careful to hold the glass door firmly after
removing the screws. (Fig. 2)
3. Gently pull down to remove the glass door from the right top
hinge and place it on a padded surface to avoid the risk of
damage. Then remove the right top hinge ○,9. (Fig. 4)
4. Unscrew and transfer hinge pin ○,7 and/or door stopper ○,8of the
bottom hinge to the opposite side. (Fig. 3)
5. Pop out the cover caps on the left side of cabinet and use them to
cover the screw holes on the right hand side.
6. Screw the alternative left top hinge ○,11, included in the fittings, on
the left hand side of cabinet. (Fig. 4)
7. Rotate the door 180° and relocate the door to the designated
position. Then screw the bottom hinge assembly on the left
designated position and tighten it after the door is leveled.
8. Transfer the handles & plugs to the opposite positions and then
reassembly the ventilation grilles.
EN
18