Brinly PCT-101BH Manuel Du Propriétaire page 9

==================================================================================================
Assembly Step 3-C
Hardware Panel 3
continue running the 3/8 x 3-3/4 in.
bolt (15) through the foot pedal (4).
Between the foot pedal (4) and drawbar, add one
3/8 in. keps nut (16) to the bolt (15) as illustrated. Finally, run the
end of the bolt (15) through the other side of the drawbar (21).
NOTE: Foot pedal can be adjusted slightly while installing bolt (15).
This will help to align the bolt with the hole on the other side of the
drawbar.
Starred edge of the waSher needS to be facing the Spring.
Assembly Step 3-D
Hardware Panel 3
1. On the outside of
the drawbar, add bolt (15)
with a 3/8 in. hex head locking nut
(11) so that the foot pedal moves
forward and backward freely.
2. Tighten nuts (16) toward the spring,
but allow movement.
English Manual
ASSEMBLY
21
16
9
16
4
15
11
16
15
16
1008577ALL-D