Sanitaire 800 Serie Guide Du Propriétaire page 3

Grounding Instructions
This appliance must be grounded. If it should malfunction or breakdown, grounding provides a path of least resistance for
electric current to reduce the risk of electric shock. This appliance is equipped with a cord having an equipment-grounding
conductor and grounding plug. The plug must be plugged into an appropriate outlet that is properly installed and grounded
in accordance with all local codes and ordinances.
Improper connection of an equipment-grounding conductor can result in risk of electric shock. Check with a qualified electrician
or service person if you are in doubt as to whether the outlet is properly grounded. Do not modify the plug provided with the
appliance. If it will not fit the outlet, have proper outlet installed by a qualified technician.
This appliance is for use on a nominal 120 volt circuit and has a grounding plug that looks like the plug illustrated in Figure A.
A temporary adapter which looks like the adapter illustrated in Figure B may be used to connect this plug to a two-pole
receptacle, as shown, if a properly grounded outlet is not available.The temporary adapter should be used only until a properly
grounded outlet, Figure A, can be installed by a qualified electrician. The green colored rigid ear, lug, or the like extending
from the adapter must be connected to a permanent ground such as a properly grounded outlet box cover. Whenever the
adapter is used, it must be held in place by a metal screw.
CAUTION: In Canada, the use of a temporary adapter is not permitted by the Canadian Electrical Code.
OUTLET BOX
GROUNDING BLADE
IS LONGEST OF THE
THREE BLADES
HOW TO ASSEMBLE
CAUTION: Completely assemble vacuum cleaner before using.
Assembly Packet is with owner's guide.
Attach the Handle
Push lower handle into handle socket on the base.
NOTE: Check to be sure slot in handle is positioned correctly,
see Detail.
Align the holes on the lower handle and the socket. Insert a 2-part
bolt (A) in the bottom center of the handle and tighten.
Push upper handle onto lower handle. Make sure grip curves away
from cleaner. Align the holes on the upper handle to the holes on
the lower handle. Insert a 2-part bolt (A) in center of the handle
and tighten.
Attach Lower Cord Hook
Make sure cord hook (B) is pointing downwards. Press the power cord
into the groove on the cord hook pulling any slack toward the base of the
cleaner. On the cord hook, find the curved tab and place in slot on lower
handle section, keep cord taut while pressing the cord hook to the left
until it snaps into slot on opposite side of handle. The hook should point
downward on the same side that the cord exits the hood.
GROUNDED
ADAPTER
METAL
SCREW
FIGURE A
DANGER
GROUNDED
OUTLET BOX
GROUNDING
FIGURE B
TAB
A B
2-Part Bolt Lower Cord Hook
DETAIL
A
B
A
3