BAFANG MAX Drive System Manuel page 53

flash for 4 seconds, indicating that maintenance
is necessary.
• the maintenance alert function can be disabled:
➞
settings maintenance alert (MA)
tenance alert (MA) ➞ 0. (Maintenance alert
can also be set via a computer. this requires a
uSB connection. See also the parameter setting
instructions).
6.5.9 Further Settings:
password Setting
When the speed field displays PSd, it is a prompt to
enter a password. Press /
password (using digits 0 to 9). Briefly press
switch between the single digits of the password. the
default password is "0512". Briefly press to switch
between the single digits of the password. the default
password is "0512". Briefly press
your setting. If the set password is wrong, the system
automatically returns to the previous interface. If the
set password is correct, the system will switch to the
setting of the wheel diameter.
DEALER MAnuAL Max Drive SySteM
6.5.10
When the speed position displays Wd, press
select the correct wheel diameter: 16/18/20/ 22/24/26,
700c, 28/29. the measurements are in inches. A wrong
➞
main-
wheel diameter can lead to speed anomalies.
After this setting, briefly press
enter the setting interface of speed limit.
to set the four-figure
to
to confirm
DISPLAy (DP C01.RS232.7)
Wheel Diameter Selection
(< 0.3 seconds) to
/ to
52