Clock Setup; Battery Installation; Power Supply; 12/24 Hour Display - THINK GIZMOS TG809 Manuel De L'utilisateur

3. CLOCK SETUP

3.1 Battery Installation

● The button battery is already fitted in the clock.
● The battery is only supplied to store the time if mains power is removed from the clock.
The clock will not function on battery power alone.
●

3.2 Power Supply

● Plug the charging cable USB-A male into a 5V/2A QC2.0 or above power adaptor.
● Connect the power adaptor to the mains socket.
● Plug the Type-C end of the USB Cable into the port on the back of the clock.
● If connected correctly, the lights on the clock should light up.
A 5V/2A QC2.0 or Above Power Adaptor is required for the wireless
charger and alarm clock to work correctly at the same time.
3.3 Setting the Time
● Press the ' ' button, the minute number will start to flash. Use the +/- buttons to adjust
the minutes.
● Press the ' ' button again, the hour number will start to flash. Use the +/- buttons to
adjust the hour.
● Press the ' ' Button again to finish setting the time.

3.4 12/24 Hour Display

Quickly double press the '
USB-A Male
IMPORTANT:
' Button to switch between 12 and 24 hour clock mode.
6
USB Type C