Dyna-Glo SIGNATURE Serie Mode D'emploi page 11

ASSEMBLY INSTRUCTIONS
11. Attach one M6 x 12 bolt (AA) into each side of the
opening on the offset top section (D), as shown.
Leave about 1/4" (6mm) of the bolt exposed.
Hardware Used
M6 x 12mm
AA
Bolt
12. Insert each of the exposed bolts into the keyholes
located on both sides of the smoker body (C)
opening. Allow the bolts to slide down to the
bottom of the keyhole before tightening.
x 2
12
11
11
D
AA
C