Lighting Settings - THOMSON 512494 Mode D'emploi

OUTDOOR 720P IP CAMERA WITH LIGHTING
Mount the camera using screws and wall plugs suitable for the type of supporting surface (the screws and
plugs included are suitable for solid walls)
To ensure the fixture is watertight, remember to feed the power cable into the rubber cover provided for
this purpose, and to place the waterproof seals over the screws before attaching the base to the wall.
Refasten the screws using the Allen key included to mount the fixture.
Screw an E27 globe with a maximum wattage of 60W into the case and then screw the globe back in.

2 - LIGHTING SETTINGS

The camera' s lighting is controlled through an infrared sensor on the surface, and it has two settings:
1 2
1. "Time" wheel: illumination time. Turn in an anti-clockwise direction to the
left to decrease the lighting duration following the detection of movement.
Turn in a clockwise direction to the right to increase this duration. Lighting
duration can be adjusted from 5 secs to 4 mins.
2. The "Lux" wheel: brightness. Turn in an anti-clockwise direction to the left to
decrease the minimum brightness emitted by the light (set to the maximum
left, the light will only come on in very dark night light). Turn in a clockwise
direction to the right to increase brightness (set to the maximum right, the
light will come on in daylight as soon as movement is detected).
C - INSTALLATION
www.thomsonsecurity.eu
EN EN
9