Martin Logan Monument 7XW Manuel De L'utilisateur page 7

WARNING! Turn your amplifier
off before making or breaking any
signal connections!
Place the speaker in the hole. Monument
6
7XW: Orient the speaker's unmarked mid-
range driver (the driver without 'MartinLogan'
printed on it) so that it is the closest to the
listener's ear level at the primary listening
position.
7 Use the supplied Torx T20 driver and an
electric drill to lock all mounting locks in
place. Use a low clutch setting on the drill.
8 Always use the Folded Motion XT tweeter in
a vertical orientation. If the speaker's instal-
lation is horizontal, the tweeter needs to
rotate 90 degrees. To do this, remove alu-
minum baffle (if installed) and using a Phillips
screwdriver, remove the four screws holding
the tweeter assembly in place. Rotate the
tweeter to the correct orientation then screw
the assembly back into place (fig 2).
9 Gently press the trim baffle into place.
10 Place the magnetic grill cover over the speaker.
7