Description; Safety System; Before First Use; Using The Appliance - Krups ZY501 Mode D'emploi

KR-CENTRIF-NC00118428 19/04/13 17:36 Page3
21. Be careful when handling the stainless steel filter basket. The small cutting blades
are very sharp. Handle very carefully. Mishandling may cause injury.
22. Fully unwind the cord before use.
SAVE THESE INSTRUCTIONS
POLARIZATION PLUG
This appliance has a polarized plug (one blade is wider than the other). To reduce
the risk of electrical shock, this plug will fit in a polarized outlet only one way. If the
plug does not fit fully in the outlet, reverse the plug. If it still does not fit, contact a
qualified electrician. Do not modify the plug in any way.

DESCRIPTION

A Pusher
B Feed tube
C Cover
D Stainless steel filter basket
E Juice collector
F Pouring spout
G Pulp collector
H Safety clamp

SAFETY SYSTEM

This appliance is fitted with a safety mechanism. To start the juice machine, the cover (C) must be
properly secured by the safety clamp (H). Opening the safety clamp (H) will stop the juice extractor.
At the end of a cycle, place the control switch (I) to OFF and wait until the stainless steel filter basket
(D) stops completely before removing the cover. The appliance will switch off automatically after 3
minutes of non-use as an added safety feature.

BEFORE FIRST USE

Unpack the appliance and place it on a solid, stable work surface.
Ensure that all packaging has been removed before starting the appliance.
We recommend that you wash all the removable parts (A, B,C, D, E, G, L, M, N) in warm soapy water
(see paragraph "Cleaning"). Before the first use rinse and dry them carefully.

USING THE APPLIANCE

Fit the juice collector (E) onto the appliance, tipping it slightly forward to pass the pouring spout through
the hole provided (see Fig. 1).
Place the stainless steel filter basket (D) in the juice collector (E). Ensure that the filter basket is properly
clipped onto the drive shaft (J). You can hear an audible click when it is positioned correctly (see Fig. 2).
Fit the cover (C) on the appliance with the ejection spout to the back (see Fig. 3).
Push the safety clamp (H) towards the back of the machine until it locks into place. The red light will
become blue.You will hear an audible "click" (see Fig. 4).
Fit the pulp collector (G) on the rear of the appliance (see Fig. 5).
I
Control switch (2 speeds)
J
Drive shaft
K Motor unit
L Juice container cover
M Foam separator
N Juice container
O Brush
P Cord storage
English
3