Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
SITE PREPARATION
IMPORTANT:
This ice maker has been designed for flush
■
install in instances where the power supply,
water supply, and drain are located in a
cabinetry.
For installation of product with utilities
■
behind the ice maker, flush install may not
be achieved.
Refer "Location Requirement" illustration
■
and table below for utility slot/hole cutout
location.
Utility Slot/Cutout Location Zone
A
9" (22.9 cm)
Dimension
B
8" (20.3 cm)
C
7" (17.8 cm)
Diameter of the hole
D
2" (5 cm)
ELECTRICAL REQUIREMENTS
WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result
in death, fire, or electrical shock.
Electrical Requirements
Power Supply
115 V, 60Hz, AC only
Circuit Breaker
15 to 20 A, fused
Receptacle
3 prong grounding-type
Outlet
IMPORTANT:
Use an outlet that cannot be turned off by a
■
switch. Do not use an extension cord.
It is recommended that this product not be
■
connected to a GFCI (Ground Fault Circuit
Interrupter) protected outlet, as nuisance
tripping of the power supply may occur.
The ice maker must be grounded. The
■
ice maker is equipped with a power
supply cord having a grounded 3 prong
plug. The cord must be plugged into a
mating, grounded, 3 prong wall receptacle,
grounded in accordance with the National
Electrical Code and local codes and
ordinances. If a mating wall receptacle is
not available, it is the personal responsibility
of the customer to have a properly
grounded 3 prong wall receptacle installed
by a qualified electrician.
Non-GFCI
SITE PREPARATION | 9
Publicité
Chapitres
Table des Matières
