Jennair JIM158XYCX Guide D'installation page 26

INSTALLATION
INSTALLING THE DRAIN PUMP
AND DRAIN HOSE (CONT.)
26 | INSTALLATION
Receptacle of the
drain pump
9
Coil the ice maker power cord into a 4"
(10.2 cm) diameter coil. Restrain the
coil with electrical tape or cable ties.
Place the coiled power cord as shown
in the illustration and plug it into the
receptacle on the drain pump.
Drain pump power
cord, clamp and screw
10
Attach the drain pump power cord to
the ice maker side wall with the clamp
and screw (removed in step 7).
Ice bin outlet
7/8" adjustable hose clamp
Drain tube (ice bin to drain
pump)
7/8" adjustable hose clamp
Drain pump reservoir inlet
New drain tube is provided in the
11
drain pump kit. Install new drain tube
to both the ice bin outlet and the
drain pump reservoir inlet using new
adjustable clamps.
NOTES:
Do not kink.
■
Trim tube length if required.
■
Drain tube
Clamp
12
Attach the drain tube to pump
discharge tube using a clamp
provided.