Installing The Drain Pump And Drain Hose - Jennair JIM158XYCX Guide D'installation

INSTALLATION
INSTALLING THE DRAIN PUMP
AND DRAIN HOSE
24 | INSTALLATION
NOTE: Do not kink, smash or damage tubes or
wires during installation.
Screws
1 Unscrew the screws attaching rear
panel to ice maker. Remove the screws
and rear panel, place them aside. For
pump models, skip to step 12.
2 Remove the old drain tube and clamp
attached to the ice maker bin.
NOTE: Discard old drain tube and
clamp.
Install the drain pump on the right side
3
of the ice maker base. Tip the drain
pump slightly to slide the mounting
tab into the mounting tab slot.
Clamp
Old drain
tube
#8-32 x 3/8" pump mounting screws
4
Align the two screw holes at the rear
of the pump. Use the two #8-32 x 3/8"
screws supplied to attach the pump to
the ice maker base.
Mounting
tab slot