Installing The Device; Commissioning The Device - Caso Germany SlimLine 2000 Instructions D'exploitation

Installing the device

•
Place the device on a stable and level surface.
•
Never place the device on a flammable surface (e.g. table cloth, carpet, etc.).
•
Do not block the ventilation slots of the device. This may overheat the device. Keep a
minimum distance of 5 to 10 cm to walls or other items.
•
Do not place the induction hotplate next to devices or objects, which react sensitively to
magnetic fields (e.g. radios, TVs, cassette recorders, computer, etc.).
•
Do not place induction hotplates next to open fires, heaters or other sources of heat.
•
The induction cooktop is not suitable for installation into other units.
•
Make sure that the mains connection cable is not damaged or squashed beneath the
device.
•
Make sure that the mains connection cable does not come into contact with sharp edges
and/or hot surfaces.
•
The device should be connected to a rolled-out extension cable with a maximum length of
3 m and a cross-section of 2 mm. If an intermediate switch is used, it must be rated at min.
16 A.

Commissioning the device

•
Prior to connecting the device, check whether the voltage indicated on the type plate
corresponds to the voltage supply in your home. A wrong connection may lead to grave
damage on the device and injury to persons.
•
The two hotplate surfaces consist of temperature-resistant ceramics. In case of damage,
even if this concern only a small tear, disconnect the device from the power supply
immediately and contact the customer service.
•
We recommend not placing any metal kitchen utensils, cookware or pan lids, knives or other
metal objects on the hotplate. These may heat up when the device is turned on.
Attention:
Place the hot pans in the hob area only. Never place them on the control panel or
the frame.
•
Do not place any magnetically objects like credit cards, cassettes etc. on the glass surface
while the device is in operation.
•
On order to avoid overheating, do not place any aluminium foil or metal plates on the device.
Warning: Please do not put the induction cooker on an iron/steel board, while operating.
•
Due to electromagnetic reason, the iron/steel board may heat and damage the bottom of the
induction cooker.
•
Do not insert any objects like wires or tools into the ventilation slots. Attention: this may cause
electric shocks.
•
Do not touch the hot surface of the ceramic field. Please note: the induction hotplate does not
heat up itself during cooking, but the temperature of the cookware heats up the hotplate!
•
If you do not use the device for an extended period, we recommend you disconnect it from
the electric outlet.
14