Application Examples; Direct Service Access Via Wlan Access Point; Connection To The Router; Connection Via Lan - Resol KM2 Manuel

5

Application examples

5.1

Direct service access via WLAN access point

The access point allows the installer to directly connect with the device without
having to access the network of the customer. All access data required can be
found on the underside of the housing.
KM2 – Internal WLAN
Controller
access point
In order to connect a mobile to the device via the WLAN access point, proceed
as follows:
1. If the WLAN LED is not illuminated, briefly press the button.
WLAN LED
The WLAN access point is activated.
2. Select the WLAN network of the device on your mobile and enter the
Network name (SSID).
The default SSID name is KM2-{12-digit serial number}.
3. Click Connect.
4. Enter the WLAN code of the device.
This code can be read from the label on the underside of the housing (WLAN-AP).
5. Establish the connection.
KM2 Web interface
Button
After the WLAN connection to the device has been established, the Web interface
can be reached with an Internet browser under the IP address http://192.168.240.1
or the controller can be parameterised over RPT. If you access the website in its
encrypted version (https), a security enquiry may appear. You can either ignore this
warning or access the unencrypted version (http).
Web-Interface: XxXxXxXxX
WLAN-AP - xxxxxxxx
SSH root xXxXXXX
5.2

Connection to the router

The device can be connected to a router via LAN or WLAN, in order to have
access to the home network and additionally to the Internet.
5.3

Connection via LAN

KM2
Controller
www
Router Internet device
27