Rating Plate; Operation - CASO DESIGN FastVac 390 Mode D'emploi

11 Vacuum chamber: Position the open end of the bag inside the chamber.
12 Sealing profile: Presses the bag tightly onto the sealing bar (17).
13 Lower gasket + 14 Upper gasket
15 Cutter: To cut the bags.
16. Air intake: Air intake connects with vacuum chamber and pump. Do not cover this air
intake when placing bag for Vacuum&Seal operations.
17 Sealing bar:
seal but not to stick to the strip. Place the bag over this sealing element.
► Do not remove the Teflon tape.
WARNING
Please observe the following safety notice to reduce the risk of burns.
► Never touch the sealing bar while the unit is operating.

15.3 Rating plate

The rating plate with the connection and performance data can be founded on the bottom
of the unit.

16 Operation

This chapter provides instructions on the proper operation of your vacuum sealer:
Contains a heating wire covered with teflon which allows the bag to
Please note
42