Hob; Selecting Burner; Electronic Ignition Hob (Depending On Model); Manual Ignition Hob - Dometic 7103 Installation Utilisation Entretien

HOB

- SELECTING BURNER

THE FLAME MUST NEVER EXTEND BEYOND THE EDGE OF THE PAN. CENTRE
THE PAN OVER THE BURNER ENSURING STABILITY ON THE PAN SUPPORT.

- ELECTRONIC IGNITION HOB (DEPENDING ON MODEL)

MAKE SURE THERE ARE NO PANS OR OTHER ANY OBJECTS ON THE BURNERS
WHEN IGNITING.
To ignite burner, gently push-in and turn the control knob to position HIGH FLAME and maintaining the knob pushed
at the same time press the electronic ignition pushbutton. Once the burner is alight maintain the knob in this position
for a few seconds to the ensure the flame remains alight.
IF THE BURNER DOES NOT IGNITE IMMEDIATELY REPEAT IGNITION AFTER
HAVING FOLLOWED EACH STEP BELOW:
• TURN THE KNOB TO "SMALL FLAME"
• PROCEED WITH MANUAL IGNITION
• CHECK THERE IS SUFFICIENT GAS IN THE GAS BOTTLE.
IF THE APPLIANCE STILL DOES NOT IGNITE SHUT OFF THE GAS SUPPLY AT
THE MAIN GAS TAP AND CONTACT YOUR LOCAL DEALER.

-MANUAL IGNITION HOB

Manual ignition when the appliance is not fitted with the electronic ignition feature or in the event of failure in the
electronic ignition.
MAKE SURE THERE ARE NO PANS OR OTHER ANY OBJECTS ON THE BURNERS WHEN IGNITING.
To ignite burner, gently push-in and turn the control knob to position HIGH FLAME and maintaining the knob pushed at
the same time light the burner with a match or gas lighter. Once the burner is alight maintain the knob in this position
for a few seconds to ensure the flame remains alight.
IF THE BURNER DOES NOT IGNITE IMMEDIATELY CHECK THERE IS
SUFFICIENT GAS IN THE GAS BOTTLE.
IF THE APPLIANCE STILL DOES NOT IGNITE SHUT OFF THE GAS SUPPLY AT
THE MAIN GAS TAP AND CONTACT YOUR LOCAL DEALER.

- HOB FLAME REGULATION

To regulate flame turn the knob to the desired cooking flame.
BURNER
AUXILIARY
Ø 47 mm
SEMI-RAPID
from 10 to 16 cm (MOD. HBH1303ILG/IRG)
Ø 62 mm
RAPID
Ø 77 mm
PAN DIAMETER
from 6 to 16 cm
from 16 to 22 cm
from 16 to 22 cm