Atag WM411STUU/A01 Mode D'emploi page 31

operation
extra functions
grease filter indicator
1 Clean the grease filters when the indicator light lights up
(see page 11, "maintenance – grease filters").
2 Put the clean filters back.
3 Erase the memory of the grease filter indicator. Hold your
hand a few centimetres away from the continued-running
grease filter indicator
symbol for three seconds.
The grease filter indicator light goes out.
The filters are
dishwasher-proof
switching the beep off
Put the extractor hood on standby. For a few seconds, hold
one hand a few centimetres away from the lighting symbol at
the same time as you hold your other hand in front of the
continued-running symbol.
Repeat this action if you want to switch the beep on again.
GB 10
duct and hood
For cleaning the stainless steel parts and the glass plate, you
can best use a mild cleaning agent (washing-up liquid) and a
damp cloth. Dry with kitchen paper or a dry cloth.
The stainless steel regains its shine if you occasionally use a
stainless-steel care product or polish. The polish applies a
dirt-resistant layer to the stainless steel. Always clean the
stainless steel in the direction of polishing.
Atag supplies cleaning and care products for extractor hoods.
Never use abrasive cleaning agents (such as Vim, green
scourers or other scouring pads) or polishing cleaning agents
(such as liquid abrasives). Never use caustic agents. These
can attack the stainless steel.
maintenance
cleaning
GB 11