Transporting The Machine; Electrical Connection; Controls - Tornado 98494 Mode D'emploi

Transporting the Machine

CAUTION – THIS MACHINE IS HEAVY

Do not attempt to lift the machine without mechanical assistance.

Do not lift the machine by the operating handle or outer cover, always lift from the chassis.

Use a mechanical lift, hoist or forklift and ensure the machine is securely in place before lifting.
Incorrect lifting techniques may result in injury.

To move the machine to the work area, lock the handle and tilt backwards to raise the front off the
floor, and wheel into position.
CAUTION – BUMPING THE MACHINE THROUGH OBSTACLES CAN DAMAGE THE MACHINE.
SMALL OBSTACLES CAN BE OVERCOME BY PULLING THE MACHINE BACKWARDS.

Electrical Connection


Before connecting the machine to the power supply, check that your supply voltage corresponds with
that marked on the rating label.
IMPORTANT – IF THE CHARGING LEAD IS DAMAGED, IT MUST BE REPLACED BY A CORD
PROVIDED ONLY BY THE MANUFACTURER OR AN AUTHORIZED SERVICE AGENT.

Controls

The main operating controls are located on the handle.
Switch Trigger, left hand
Used to switch motor ON and OFF. Can only
be operated with handle in working position,
and if left hand interlock button has previously
been pressed.
Interlock Button, left hand
This must be pressed initially to enable left hand
switch trigger to switch the motor on.
Switch Trigger, right hand
Used to switch motor ON and OFF. Can only
be operated with handle in working position,
and if right handle interlock button has
previously been pressed.
Interlock Button, right hand
This must be pressed to enable right hand
switch trigger to switch the motor on.
5