Switching Off The Garden Shredder; Folding Out The Branch Guide; Folding In The Branch Guide; Tool Box Shredding - Viking GB 460 Manuel D'utilisation

GB 460, GB 460 C:
● Standing behind the machine (note the
working area ( 9.4) press against the
axle with one foot (see illustration).
● Clasp the handle (2) of the recoil starter
rope (3) firmly in one hand and hold.
● Slowly pull out the recoil starter rope (3)
to the point of compression resistance.
Then pull forcefully and quickly to arm's
length.
Slowly return the recoil starter rope (3)
so that it is rolled up again.
Repeat the procedure until the engine
starts.
GB 460 C:
● When the engine is running, deactivate
the choke again immediately. (
11.2 Switching off the garden
shredder
Risk of injury!
Do not step into the ejection area
when switching off!
Do not stand on the engine side
and bend over the machine when
switching off the garden shredder –
Danger of burns due to hot engine
components.
Beware of the work tools running
on for several seconds before
coming to a standstill after
switching off the engine.
0478 216 9905 A - EN
Note the pictogram on
the front of the upper
chute.
Only switch off the
engine when there is
no further shredding
material in the
machine, otherwise
this could cause a
blockage at one of the
two blade discs when the machine
is used next.
– Note the direction indicated in the
illustration and the marked location for
switching off.
● The garden shredder is switched off by
turning the black knob (1) (symbol O) at
8.2)
the On- / Off switch (2) (in either
direction). The garden shredder engine
stops.
The engine and the blade discs come to
a standstill within a few seconds.
18
11.3 Folding out the branch
guide
Risk of injury:
For safety reasons, only fold the
branch guide (2) in and out when
the machine is switched off.
● Press branch guide lock (1) upwards
and hold.
● With your other hand, move the branch
guide (2) slowly to the rear (away from
the machine).
● Release the branch guide lock (1) again
and fold out the branch guide (2) as far
as possible.

11.4 Folding in the branch guide

Risk of injury:
For safety reasons, only fold the
branch guide (1) in and out when
the machine is switched off.
Danger of pinching:
When closing the branch guide,
make sure that your fingers are not
pinched between the branch guide
and the feed chute.
● Slowly fold in the branch guide (1) as
far as possible (press against the
machine) until it latches into the branch
guide lock (2).
11.5 Tool box
To open the tool box:
● Press the tab (1) downwards and
hold.
● Fold down the tool box lid (2).
Closing the tool box:
19
● Push the tool box lid (2) until the tab
latches into place.
11.6 Shredding
● Push the garden shredder onto firm and
level ground and set down safely.
● Put on thick gloves, safety glasses and
hearing protection.
● Check the oil level, fuel and tyre
pressure. ( 7.8), (
20
21
12.12)
63