Removing The Blade Cover; Installing The Blade Cover; Installing The Feed Chute Ato; Installing The Ejection Chute Extension - Viking GB 460 Manuel D'utilisation

7.3 Removing the blade cover

● Hold the blade cover (1) at the
bore and lift off the cover.

7.4 Installing the blade cover

● Insert the blade cover (1) under
the counter-blade (2).
Then press down the blade cover (1).
When properly installed, the blade
cover (1) must lie against the blade disc
correctly.
7.5 Installing the feed chute
ATO 400
● Remove the blade cover. (
● Insert the two fastening hooks (1) on
feed chute ATO 400 (K) into the two
openings in the basic unit (2).
● Tilt the feed chute ATO 400 (K)
forwards to the stop.
● Screw in the On / Off switch (3) and
tighten.
Following assembly, check that the
feed chute ATO 400 is correctly
engaged in both openings in the
basic unit.
7.6 Installing the ejection chute
extension
● Carefully set the machine on its
back.
Place cardboard underneath in
order to prevent damage.
0478 216 9905 A - EN

Installing the ejection chute extension

● Attach the ejection chute extension (L),
5
engage the hooks (1) in the apertures
on the housing (2) from above, turn
downwards and push on the
retainers (3) at the side.
● Screw in the screws (O) and tighten to
1 - 2 Nm.
6
In order to facilitate installation of
the guiding plate, we recommend
loosening the left wheel carrier
slightly.
● Loosen the screw (4) at the left wheel
carrier by approx. 5 turns.
7

7.7 Installing the plates

7.3)
1 Install the guiding plate
● Insert the guiding plate (N).
Ensure that the guides on the guiding
plate (1) are correctly located in the
guides of the ejection chute
extension (2).
● Fit screw (P) and tighten with nut (R).
● Screw in the screws (O) and tighten to
1 - 2 Nm.
2 Install the ejection chute plate
● Insert the ejection chute plate (M).
● Screw in the screws (O) and tighten to
1 - 2 Nm.
● Fit screws (Q) and tighten with nuts (R).
8
Any slight tensions occurring in the
ejection chute can be compensated by
readjusting the screws.
Tightening the screws of the
wheel carrier mounting
● Stand the machine up and check
for correct seating of all attached parts.
● Tighten screws (1, 2) of the wheel
carrier mounting to 10 - 12 Nm.
After tightening screws, check that
both wheel carriers are securely
seated.

7.8 Fuel and engine oil

Top up engine oil before initial start
( engine instruction manual)!
Engine oil
Please consult the engine instruction
9
manual for the type of engine oil to be used
and the oil capacity. Check the oil filling
level at regular intervals (
instruction manual). Avoid exceeding or
falling below the correct oil level.
Fuel
Recommendation:
Fresh good quality fuel, normal unleaded
petrol ( engine instruction manual)! Use
a funnel when filling the tank with fuel (not
included in standard equipment). Note the
warnings in the section "For your safety".
( 4.)
10
11
see engine
59