Setup; Operation; Maintenance; Troubleshooting - Greenlee SDG45 Manuel D'instructions

Setup

Connect the high-pressure hydraulic hose to hydraulic
pump and the cable cutter.
Note: Clean the quick-change couplers before making
connections. Hand-tighten the couplers until all threads
are fully engaged. Do not use tools.

Operation

Electrical shock hazard:
This tool is not insulated. When
using this unit near energized
electrical lines, use only certified
nonconductive hoses and proper
personal protective equipment.
Failure to observe this warning could
result in severe injury or death.
Cutting hazard:
Keep hands away from cutting jaws.
Failure to observe this warning could
result in severe injury or death.

Troubleshooting

Problem
The jaws will not close.
Cutter jaws do not overlap at least
0.030" (0.76 mm) on the centerline.
Greenlee Tools, Inc.
Cutting Cable—SDG45, SDG55, SDG85, and SDG105
1. Open the head by using the pull pin.
2. Position the cable in the open cutting head.
3. Close the cutting head and insert the pull pin.
4. Follow the instructions supplied with the pump.
Cutting Cable—SDK105
1. Position the cable in the open cutting head.
2. Follow the instructions supplied with the pump.

Maintenance

• Keep all parts clean and lubricated with a light coat of
moly-filled grease.
• Inspect blades for wear or nicks and replace if
necessary.
Probable Cause
Hydraulic fluid level may be low.
Worn or damaged cutter jaws.
6
Remote Cable Cutters
Probable Remedy
Check hydraulic fluid level. Add fluid
if necessary
Replace the cutter jaws.
4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070