Frequency/Channel Adjustment; Frequency Step Selection - Midland CT3000 Mode D'emploi

Frequency/channel adjustment

In frequency mode you can change the frequency number with the main knob:
clockwise to increase the value and counter-clockwise to reduce it.
Each "clic" you hear from the knob corresponds to an increase or decrease of
the frequency (it is the same as the set STEP).
The desired frequency can also be manually set thanks to numeric keypad on
the microphone. If the frequency does not match with the current frequency
STEP, it will be automatically selected the nearest available frequency.
In channel mode it is possible to change the channel by turning the main knob.
Note: it is possible to adjust the frequency or the channel through the UP/DOWN
keys on the microphone.

Frequency STEP selection:

The correct frequency STEP allows you to select the exact rx frequency
through the main knob or the UP/DOWN buttons (if they are set for the
frequency mode).
The following frequency steps can be selected: 2,5 kHz - 5 KHz - 6,25 kHz -
10 kHz - 12,5 kHz - 20 kHz - 25 kHz - 30 kHz - 50 kHz.
To set the desired frequency STEP press FUN for 2 seconds, select the option
FUNCTION MENU and then STEP. Now select the desired frequency STEP by
turning the main knob or the UP/DOWN controls.
To confirm push PTT or wait for 5 seconds.
Receiving
When the radio is turned on it immediately receives incoming signals; the
received signal strength is shown with the green bar in the upper side of the
display.
Make sure you set the proper frequency mode (VHF or UHF)!
Note: To immediately mute the speaker, press . Audio: MT will appear in the lower
part of the display. Press again to enable the audio; now the display will show
AUDIO: Esc.
Midland CT3000 instruction guide | 11