Replacing Fuses; Installing The Microphone; Installing An Antenna; External Speakers - Midland CT3000 Mode D'emploi

Replacing fuses

If the fuse blows, try to find a cause before replacing it. If necessary, contact a
service center for assistance.
The fuse on the rear of the radio has a current rating of 10A
10A 250V FUSE
IN-LINE FUSE HOLDER

Installing the microphone

Plug-in the microphone into the proper socket on the front panel of the radio.
If you prefer, the microphone can also be hung up thanks to its holder supplied
in the package.

Installing an antenna:

• Place the antenna as high as possible
• The longer is the antenna, the better will be the performance
• If possible, mount the antenna in the centre of the surface
• Keep the antenna cable away from noise sources, such as the iginition
switch, gauges, etc
• Prevent cable damage during antenna installation
Attention:
To prevent damage, never operate your radio without connecting a pro-
per antenna. A periodical control of the cable and of the S.W.R. is recommended.

External speakers

If you use external speakers, the impedance must be 4 Ω or 8 Ω. The external
speaker jack accepts a 3.5mm mono plug.
4 | Midland CT3000 instruction guide