Maintenance - Greenlee 855GX IntelliBENDER Manuel D'instructions

Maintenance

Refitting 1" to 2" Combination Shoe
The base 1" to 2" shoe can only be refitted in one
position.
1. Slide the shoe onto the spindle and orient it so the
EMT hook (silver) is about 90° clockwise of the
sprocket spoke with two drive lug holes.
2. Fully slide on the shoe so the drive lugs engage into
the sprocket holes.
3. Secure the shoe with the shoe retainer.
Replacing the Fuse
For continued protection against risk of fire and
electric shock, replace ONLY with same manufacturer,
type, and rating of fuse.
Failure to observe this warning could result in severe
injury or death.
If the fuse needs to be replaced, use only a Cooper
Bussmann GBB-30 Very Fast-Acting fuse, 1/4" x 1-1/4"
(6.3 x 32 mm).
Adjusting the Bender Settings
1. From the home screen, press the button next to
"SET UP" to display the screen below.
Greenlee / A Textron Company
855GX Electric Bender
2. From this screen, press the button next to the type
of adjustment you want to make:
a. "ADJ LCD" displays a screen to change the
contrast of the LCD on the bender. Press "+" to
increase the contrast; press "–" to decrease the
contrast.
b. "ADJ TIME DATE" displays a screen to set the
time and date as stored in the 855GX. This
setting is for the battery-operated real-time clock
for the system. This clock is used for setting the
time and date stamp when saving files to a USB
thumb drive.
c. "UNITS" displays a screen to switch from inches
to centimeters.
d. "RESET" returns the 855GX to its original factory
settings, including erasing any locally stored
bend programs.
e. "ADJ ANG" displays the screen below, which
adjusts the angle slightly to correct for the
particular conduit being used. Press "+" and
"–" to adjust the value. When the desired value
is obtained, press "SAVE" to permanently store
the value into the bender. The conduit type and
size being adjusted appear on the screen. If
the conduit type and size shown do not match
what you want to adjust the settings for, then
either load in that type of conduit for smart auto
sensing, or go back and manually set the bender
to the particular conduit type and size you want
to adjust.
For example, if the particular size you are
bending is consistently overbent by 2°, press
"–" until –2° is displayed. Likewise, press "+" if
the conduit is consistently underbent.
27
4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070