Setup; Operation - Greenlee 855GX IntelliBENDER Manuel D'instructions

Setup

Always use safety glasses. Everyday
glasses only have impact resistant
lenses; they are NOT safety glasses.
When using in dusty environment, use
face or dust mask.
Failure to wear eye protection could
result in serious eye injury from flying
debris.
Refer to the "Identification" section of this manual.
1. Position the bender so that there is room to load
conduit and engage the rear wheel brake bar.
2. Place the bender in the desired vertical or horizontal
bending position.
3. Plug the bender into a grounded 20 amp outlet.
4. Plug the pendant switch into the pendant receptacle
(28).
Greenlee / A Textron Company
855GX Electric Bender

Operation

Do not use this tool in a hazardous
environment. Hazards include flam-
mable liquids, gases, or other materi-
als. Using this tool in a hazardous
environment can result in a fire or
explosion.
Failure to observe this warning will
result in severe injury or death.
Electric shock hazard:
• Inspect the power cord before
use. Repair or replace the cord if
damaged.
• Connect the power cord to a
120 volt, 20 amp receptacle on a
ground fault protected circuit only.
Refer to "Grounding Instructions."
• Do not modify the power cord or
plug.
• Disconnect the unit from power
before servicing.
Failure to observe this warning could
result in severe injury or death.
Pinch points:
• Keep hands away from bending
shoe, rollers, and conduit when
bender is in use.
• Support conduit when unloading.
Conduit can become loose and fall
if not properly supported.
Failure to observe these warnings
could result in severe injury or death.
Disconnect tools before servicing and when chang-
ing accessories such as shoes, rollers, and the like.
Accidental start-up could result in serious injury.
Failure to observe this warning could result in severe
injury or death.
10
4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070