Emptying The Evaporation Trap Container - Mettler Toledo XPR26PC Guide De L'utilisateur

The pump is assembled.
The outlet pump tube is placed in a container suitable for liquid waste.
1 Activate the light barrier (1), or press .
The evaporation trap door (2) opens.
2 Introduce the pump probe (3) into the pipetting container
(4).
3 Switch on the pump (5).
The liquid is pumped out and collected in the
container for liquid waste.
4 Switch off the pump (5).
5 Reassemble the balance.
The balance is ready to be used.
See also
Assembling the pump Page 18

5.2.3 Emptying the evaporation trap container

NOTICE
Damage to the pump due to inapropriate handling
If the pump is switched on when it is not in use, it can get damaged.
Switch off the pump when it is not in use.
The pump is assembled.
The outlet pump tube is placed in a container suitable for liquid waste.
1 Remove the evaporation trap door (1).
2 Carefully remove the evaporation trap cover (2).
3 Introduce the pump probe (3) into the evaporation trap
container (4).
4 Switch on the pump (5).
The liquid is pumped out and collected in the
container for liquid waste.
5 If required, use the pump to empty the pipetting container
(6), see [Emptying the pipetting container Page 18].
6 Switch off the pump (5).
7 Altervatively, remove the evaporation trap container (4) to
empty it.
8 Reassemble the balance.
See also
Assembling the pump Page 18
Pipette Calibration Balances
1
3
2
4
1
2
3
4
6
5
5
19