Atag CX14411A Mode D'emploi page 187

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

USING THE MICROWAVE SETTING
Preparation guidelines for rice and pasta
Rice
Use a large, glass Pyrex dish with lid� (Take into consideration that rice
doubles in volume during cooking�) Keep covered during cooking� Stir after
cooking and before the standing time� Add salt or herbs and butter� The rice
may not have absorbed all the water after cooking is completed�
Pasta
Use a large, glass Pyrex dish� Add boiling water and a pinch of salt and stir it
all thoroughly� Do not cover during cooking� Stir several times during and after
cooking� Cover during the standing time and then drain well�
Dish
Portion
White rice
250
(parboiled)
375
Brown rice
250
(parboiled)
375
Mixed rice
250
(rice + wild rice)
Mixed grains
250
(rice + grain)
Pasta
250
WARMING UP
The microwave oven only needs a fraction of the time a traditional oven requires to
warm up dishes�
Dividing and covering
Avoid warming up large pieces of food� They may become overcooked and dry out before
they are warm enough inside� Warming up smaller pieces works better� If you cover dishes
during the warming up, you prevent them from drying out�
Power settings
Different power settings can be used to warm up dishes� In general it is advisable to use a low
power for delicate dishes or dishes which heat up fast, such as fruit pie�
Stirring
For best results, stir dishes thoroughly or turn them over during the warming up� If possible, stir
one more time before serving� Stirring is particularly important if you are warming up liquids�
Warming up and standing times
If you are warming up dishes for the first time, it is useful to note down the time required, so
that you can consult this in the future� Avoid overheating� If you are not sure about the cooking
time, it is better to stick to a short time� In that case you can always add extra time if you need
it� Always make sure that warmed up dishes are heated thoroughly�
Let dishes stand for a short while after warming up to ensure that the temperature is evenly
distributed� The recommended standing time after warming up is 2 - 4 minutes�
Power
Time
(g)
(W)
(min�)
17 - 18
800
18 - 20
20 - 22
800
22 - 24
800
17 - 19
800
18 - 20
800
10 - 11
Standing time
(min�)
Add 500 ml of cold water�
5
Add 750 ml of cold water�
Add 500 ml of cold water�
5
Add 750 ml of cold water�
5
Add 500 ml of cold water�
5
Add 400 ml of cold water�
Add 1000 ml of warm
5
water�
Instructions
EN 19

Publicité

Table des Matières
loading

Table des Matières