Allmand Night-Lite V Serie Instructions D'installation page 9

2. Install the driver assembly (I, Figure 2) with installed
input and ouput cords into the Night-Lite V-Series
unit using the hardware (J, Figure 2) removed in
Disassembly Step 4.
2
I
J
3. Take the loose ends of the output cord (K, Figure 3),
input 1 & 2 cord (L, Figure 3), and input 3 & 4 cord (M,
Figure 3) from the LED driver assembly (N, Figure 3)
and run each cord over the fuel tank and under the
engine to the circuit breaker box. Install the cords into
each designated cord grip (O, Figure 3) until the outer
insulation is flush with the top of the cord grip inside
the control box. Hand tighten cord grips on cords plus
1/4 turn, and do not over tighten.
J
J
3
O
K
M
L
N
en
9
English