Allmand Night-Lite V Serie Instructions D'installation page 7

4. Remove the hardware (O, Figure 4) securing both
ballast box assemblies in place. Set the hardware of
one ballast box aside as it will be used in Assembly
Step 2. Remove both ballast box assemblies with
attached ballast cords (P, Figure 4).
4
P
O
O
5. Tower lamp disassembly. Steps for disconnecting
lamps and wiring are as follows:
a. Remove light bar cover (Q, Figure 5b) and hardware
on top side of the light bar. Set the hardware and
cover aside as they will be re-installed in Assembly
Step 1-d.
b. Cut and remove any zip ties holding wires together.
Use caution as not to cut or damage any wires.
c. Locate all lever locks inside the light bar, and
remove the lever locks (R, Figure 5a) from the lamp
and tower wires. Set aside the four 2-port lever
locks as they will be used in Assembly Step 1-c.
Discard the remaining lever locks.
d. Loosen the cord grips and nuts (S, Figure 5a) in the
light bar and remove all lamp cords.
e. Remove the hardware (T, Figure 5b) securing lamp
fixtures in place. Set hardware aside as it will be
used in Assembly Step 1-a. Remove all four lamp
fixtures (U, Figure 5b).
O
5a
S
5b
S
R
Q
T
U
en
7
English