Allmand Night-Lite V Serie Instructions D'installation page 6

2. Old style circuit breaker box disassembly. Skip to
Disassembly Step 3 if Night-Lite V-Series unit is
equipped with an new style circuit breaker box. Steps
for disconnecting wiring are as follows:
a. Remove hardware (G, Figure 2a) securing the circuit
cover panel (H, Figure 2a) to the circuit breaker box.
Set hardware aside as they will be re-installed in
Assembly Step 7-d. Lay open cover panel from box.
b. Locate where the ballast cords and the tower cord
connect the control box.
c. Locate the neutral isolator (I, Figure 2b) and remove
nut holding wires in place. Set nut aside as it will
be used in Assembly Step 6-a. From each ballast
cord remove each white wire. From the tower cord
remove the white wire and the white with black stripe
wire. Leave all other white wires on isolator.
d. Locate the ground bolt (J, Figure 2b) and remove
nut holding wires in place. Set nut aside as it will
be used in Assembly Step 6-b.. From each ballast
cord remove each green wire with ring terminal end.
From the tower cord remove the green wire and
orange wire. Leave all other green wires on ground
bolt.
e. Locate the 2-port lever locks (K, Figure 2b) that are
connected to black wires leading from the 725 light
relays and the black wires leading from the ballast
cords. Remove the ballast cord black wires from
lever locks.
f. Locate the 2-port lever locks (L, Figure 2b) that
connect ballast cord red wire and the remaining
tower cord wires. Remove the lever locks
connecting ballast cord wires to tower cord wires.
Those connections are red to black, red to red with
black stripe, red to red, and red to blue. Set lever
locks aside as they will be used in Assembly Step
7-b.
g. Loosen cord grips and completely remove the four
ballast cords from the control box.
2a
G
6
2b
L
Tower
3. Remove the hardware (M, Figure 3) securing the
front cover (N, Figure 3) to the Night-Lite V-Series
unit. Remove the front cover. Set the hardware and
the front cover aside as they will be re-installed in
Assembly Step 8.
3
M
G
H
L K L L
K
Ballast 1 Ballast 3
Ballast 2
M
K
K
I
J
Ballast 4
M
N
www.allmand.com