Allmand Night-Lite V Serie Instructions D'installation page 5

Kit Installation: Disassembly
1. New style (outlet) circuit breaker box disassembly.
Skip to Disassembly Step 2 if Night-Lite V-Series
unit is equipped with an old style circuit breaker box.
Steps for disconnecting wiring are as follows:
a. Remove hardware (A, Figure 1a) and top cover
(B, Figure 1a) from the circuit breaker box. Set
hardware and cover aside as they will be re-installed
in Assembly Step 5-d. Lay open circuit panel (C,
Figure 1a) from box.
b. Locate where the ballast cords and the tower cord
connect the control box.
c. Locate the neutral isolator (D, Figure 1b-c) and
remove nut holding wires in place. Set nut aside
as it will be used in Assembly Step 4-a. From each
ballast cord remove each white wire. From the tower
cord remove the white wire and the white with black
stripe wire. Leave all other white wires on isolator.
d. Locate the ground bolt (E, Figure 1b-c) and remove
nut holding wires in place. Set nut aside as it will
be used in Assembly Step 4-b. From each ballast
cord remove each green wire with ring terminal end.
From the tower cord remove the green wire and
orange wire. Leave all other green wires on ground
bolt.
e. Locate the terminal strip (F, Figure 1b-c) inside the
circuit breaker box. Leading from the ballast cords
remove the black and red wires from the terminal.
Leading from the tower cord remove the black,
red with black stripe, red, and blue wires from the
terminal. Do not remove the black wires leading
from the 725 light relays.
f. Loosen cord grips on the ballast cords and
completely remove the four ballast cords from the
circuit breaker box.
1a
B
A
1b
D
1c
Tower
A
A
C
Ballast 1
Ballast 2
F
D
F
Ballast 3
Ballast 4
E
Ballast Wiring
E
Tower Wiring
en
5
English