Allmand Night-Lite V Serie Instructions D'installation page 3

2a
Driver 2
Driver 4
2b
F
Driver 1
D
Driver 3
Front of Driver Panel
E
Input 1 & 2
Output
Input 3 & 4
Back of Driver Panel
3. LED Output driver cord subassembly. Steps for
assembling the LED driver output cord to the Conssin
4-LED drivers panel assembly are as follows:
a. Loosen the Output cord grip (G, Figure 3). From the
kit contents, run one end of the LED driver output
cord (H, Figure 3, Ref. 8) through the cord grip.
b. Locate the lever locks that are coming from the
outputs of the LED drivers. Connect the LED driver
output cord wires with the lever locks. Connect the
black wire (I, Figure 3) of the LED output cord to the
brown wire coming from LED driver #1. Connect the
white wire (J, Figure 3) to the blue wire coming from
LED driver #1. Connect the green wire (K, Figure
3) to the blue wire coming from LED driver #2.
Connect the red wire (L, Figure 3) to the brown wire
coming from LED driver #2. Connect the blue wire
(M, Figure 3) to the brown wire coming from LED
driver #3. Connect the orange wire (N, Figure 3) to
the blue wire coming from LED driver #3. Connect
the white with black stripe wire (O, Figure 3) to the
blue wire coming from LED driver #4. Connect the
red with black stripe wire (P, Figure 3) to the brown
wire coming from LED driver #4.
3
I
K
M
O
J
L
N
P
G
H
en
3
English