Allmand Night-Lite V Serie Instructions D'installation page 2

Allmand Parts & Service
If uncertain about any of the information in this instruction,
or if questions or problems arise, contact the Allmand
service department at 1-800-562-1373, or contact through
the Allmand website, www.allmand.com
Model This Instruction Covers
• Night-Lite V-Series
Kit Instructions Description
These kit instructions cover the conversion of metal halide
SHO lights to Conssin LED lights for Night-Lite V-Series.
Kit Contents
Locate and identify the kit contents using the table below.
Ref Description
1. 1/2-13 nyloc hex nut
2. 1/2-13 x 1-1/4 hex head bolt
3. 1/2 flat washer
4. Conssin LED light
5. Conssin 4-LED drivers panel assembly
6. LED light CSA stop bracket
7. LED driver input cord
8. LED driver output cord
9. 2 wire lever locks
10. 8" cable tie
Before Kit Installation
1. Shut down the unit and allow ample time for engine
and lamps to cool. Refer to operator's manual.
DANGER
Electrocution Hazard
• Attempting to install the kit without first shutting down
the unit will result in death or serious injury. Shut down
the unit before installing the kit.
WARNING
Burn Hazard
• Contact with hot surfaces of the engine and lamps
could result in death or serious injury. Always keep
clear of the engine, lamps and other hot areas of the
light tower.
2. Disconnect the battery, black negative (-) cable first,
followed by red positive (+) cable. Refer to operator's
manual.
2
DANGER
Electrocution Hazard
• Attempting to install the kit without disconnecting the
battery will result in death or serious injury. Disconnect
the battery before installing the kit.
Kit Installation: Subassembly
1. Conssin LED light subassembly. Steps for assembling
the LED light CSA stop bracket to the Conssin LED
light are as follows:
a. From the kit contents install the LED light CSA stop
bracket (A, Figure 1, Ref. 6) onto the Conssin LED
light yoke bracket (B, Figure 1, Ref. 4) using the 1/2-
13 nyloc hex nut, 1/2-13 x 1-1/4 hex head bolt, and
1/2 flat washer (C, Figure 1, Ref. 1, 2, & 3).
b. Repeat step on another Conssin LED light. On the
other two repeat the same step, but on the opposite
Qty
side of the light yoke bracket.
4
1
4
4
4
1
C
4
2
2
8
8
B
2. Locate the Conssin 4-LED drivers panel assembly
(D, Figure 2a, Ref. 5) from the kit contents. The LED
drivers on the panel are numbered #1 through #4 as
shown in Figure 2a. Remove the hardware (E, Figure
2b) securing the LED driver junction box (F, Figure 2b)
to the LED driver panel. Set hardware aside as it will
be used in step 7. Open junction box.
A
www.allmand.com
C