Allmand Night-Lite V Serie Instructions D'installation page 10

4. New style (outlet) circuit breaker box input 1 & 2
cord and input 3 & 4 cord wiring connections. Skip
to Assembly Step 6 if Night-Lite V-Series unit is
equipped with an old style circuit breaker box. Steps
for connecting input wiring are as follows:
a. Locate the neutral isolator (P, Figure 4a) and
connect the white wire with a ring terminal from each
input cord. Secure the wires to the isolator by using
the nut that was removed in Disassembly Step 2-b.
b. Locate the ground bolt (Q, Figure 4a) and connect
the green wire with a ring terminal from each input
cord. Secure the wires to the ground bolt by using
the nut that was removed in Disassembly Step 2-c.
c. Locate the terminal strip and the terminals that have
one side connected to black wires leading from
the 725 light relays. Connect the black wire from
the input 1 & 2 cord (R, Figure 4a) to the terminal
with the black wire from light relay 1. Connect the
red wire from the input 1 & 2 cord (S, Figure 4a) to
the terminal with the black wire from light relay 2.
Connect the black wire from the input 3 & 4 cord (T,
Figure 4a) to the terminal with the black wire from
light relay 3. Connect the red wire from the input 3
& 4 cord (U, Figure 4a) to the terminal with and the
black wire from light relay 4.
d. Secure wires with zip ties (Ref. 10).
5. New style (outlet) circuit breaker box output cord and
tower cord wiring connections. Steps for connecting
the ouput and tower wiring are as follows:
a. Remove the ring terminals from the tower cord. Strip
insulation just enough so that the bare wire can be
inserted into a lever lock.
b. Using the 2-port lever locks (Ref. 9) from kit contents
connect the output cord wires to the tower cord
wires in the control box. Connect the output cord
red with black stripe wire to the tower cord red with
black stripe wire (V, Figure 4b). Connect the white
with black stripe wire to the white with black stripe
wire (W, Figure 4b). Connect the blue wire to the
blue wire (X, Figure 4b). Connect the orange wire to
the orange wire (Y, Figure 4b). Connect the red wire
to the red wire (Z, Figure 4b). Connect the green
wire to the green wire (AA, Figure 4b). Connect
the black wire to the black wire (BB, Figure 4b).
Connect the white wire to the white wire (CC, Figure
4b).
c. Secure wires together with zip ties (Ref. 10).
d. Close up the circuit panel on the box (DD, Figure
4c). Using the hardware (EE, Figure 4c) and cover
(FF, Figure 4c) removed in Disassembly Step 1-a,
install the cover onto the circuit breaker box.
10
4a
Light Relay 1
Input 3 & 4
Input 1 & 2
P
R S T
4b
Tower
Z
CC BB AA
Light Relay 4
Light Relay 3
Light Relay 2
U Q
Output
W
Y X V
www.allmand.com