Tractel Group Corso Instructions D'emploi Et D'entretien page 16

side plates, must be repaired by an
approved engineer before it is used again.
It is also essential to regularly check the
condition of the traversing beam and if
necessary
accumulation of grease or dust which could
prevent the trolley from moving correctly.
VI - TROUBLESHOOTING
If the trolley does not move smoothly and
freely along the traversing beam :
• Check that there is no obstacle on the
traversing beam.
• Check that the running wheels run
GB
smoothly and correctly.
• Check that the running wheel pins are
not damaged.
• Check that the spacing of the trolley is
correctly adjusted in relation to the width
of the traversing beam.
• Check that the curved radius of the
traversing beam is not smaller than the
VIII - SERVICING AND LUBRICATION
Checks
Check general condition
of trolley
Visual inspection of side
plates and wheels
(cracks, distortion)
Visual check of running
wheels for wear and
condition of hand chain
Check condition of
traversing beam
General inspection of parts
of the trolley for wear
clean it to prevent
technical capacities of the trolley used.
• Check that any curve is not distorted or
twisted at any point.
• Check the good surface condition of the
the lower flange of the beam.
VII - HEALTH AND SAFETY AT WORK
It is the responsibility of every company to
ensure that its employees have been fully
and properly trained in the safe operation of
the equipment.
Before using the equipment, check that all
the safety devices are in place and operate
correctly (section VI-5).
It is recommended that corso trolleys must
have an initial inspection on first installation
and subsequent periodic inspection. Check
local regulations and requirements.
Frequency
Daily
Quarterly
Six monthly
Six monthly
Annually
9
Person
Operator
Operator
Operator
Operator
After sales service centre