Festo CMFL Notice D'utilisation page 31

CMFL
Connection 4 power supply
Warning
Damage to the device The power supply inputs of the CMFL have no special
protection against overvoltage.
• Make sure the permissible voltage tolerance is never exceeded (
Warning
Use only power sources which guarantee a secure electrical isolation of the
operating voltage as per IEC/DIN EN 60204-1. Observe also the general require-
ments for PELV power circuits as per IEC/DIN EN 60204-1.
Connection
A1 A2
1)
Cable colours with KPWR motor cable
Fig. 8
Connect the stud bolts 5 at low
•
impedance to the earth potential.
Festo – CMFL – 1304b English
Pin Designation
A1 Load voltage
A2 Load voltage
– Earth terminal
(housing)
Function Cable colour
+48 VDC load Black 1
GND load Black 2
FE –
5
Fig. 9
Fig. 10).
1)
31