Anova MG246 Manuel D'instructions page 100

Hot start:
To warm start the engine immediately after it has stopped, follow steps 1 - 2 - 3 - 4 -
6 - 7 - 10 - 11 of the above procedure, making sure that the primer bulb is activated
only 2-3 times. .
■OIL SUPPLY CHECK
After starting the engine, run the chain at medium
speed and check if the chain oil is dispersed as
shown in the figure. The chain oil flow can be
changed by inserting a screwdriver into the hole at
the bottom of the clutch side. Adjust according to your
working conditions.
Chain Oil Flow Adjusting Shaft Rotate Shaft
Clockwise - Rich Flow
Rotate shaft counter clockwise - Poor flow
The oil tank should be almost empty by the time
the fuel is used up. Be sure to refill the oil tank
each time you reload the saw.
■CLUTCH FUNCTIONAL CHECK
Before each use, you must confirm that there is no chain movement when the
chain saw is idling.
■
CARBURETOR ADJUSTMENT
The carburetor in your unit has been adjusted at the factory, but may
require fine tuning due to changing operating conditions. If it is necessary
to adjust the carburetor, contact your dealer or maintenance service
center of the manufacturer or importer. Do not adjust it by yourself.
Before adjusting the carburetor, make sure they are supplied with fresh,
clean fuel / air.