Skiddoü Bjorg Guide D'utilisation page 10

List of parts:
1.
NOTE! Make sure all parts listed below are available before starting the assembly process.
no.
A
B
C
D
E
Assembly instructions:
2.
Place the fork with front wheels (C) in the opening in the bottom part of the ride-on body (A), as
shown in Figure 1. NOTE!: Make sure that the smaller wheels are oriented towards the front of the
ride-on body (Fig. 2). Hammer the fork with front wheels using a rubber mallet or a different tool,
such that the fork shaft fully slides into the opening in the body (Fig. 3). The next step is to install
the handlebars (B), which should be placed in the opening in the top part of the body (Fig. 4).
NOTE!: In order to facilitate handlebars assembly, gently rock the handlebars right and left when
sliding into the opening. Tighten the handlebars screw until significant resistance is felt, using
a wrench or the attached assembly pipe (E) and a screwdriver. NOTE!: The handlebars should
be aligned straight with the wheels during the assembly. Cover the opening using the attached
handlebars pad (D) (Fig. 5). The correctly assembled product is presented in Fig. 6.
3. Product use:
To move the ride-on toy, sit down in the seat, place the feet in the front part of the product
and then move the handlebars repeatedly left and right, smoothly, but dynamically - the ride-
on toy will move forward. To reverse, turn the handlebars at a 180 degrees angle and move the
handlebars as described above. To stop, stop turning the handlebars and wait for the toy to
slow down and place the feet on the ground.
If the handlebars become loose or if handlebars motion does not propel the toy correctly, the
nut might not have been tightened enough during the assembly. Remove the pad from the
handlebars and repeat steps shown in Figure 5.
4. Cleaning, maintenance and storage:
Clean using a wet and soft sponge or cloth. Protect the product against moisture, water and
extreme temperatures.
5. Warranty conditions:
1. The warranty is provided by skiddoϋ Polska Sp. z o.o. Sp. k. with its main office at
Kopanina 34, 60-105 Poznań, Poland.
2. The warranty covers skiddoü brand products.
3. skiddoϋ Polska Sp. z o.o. Sp. k. guarantees correct functioning of the product according
to technical conditions of use described in the user manual.
4. The warranty covers a period of 24 months, starting from the product sale date. If the
product is purchased by a company (VAT invoice), the warranty covers a period of 12
months.
5. The warranty cover may be extended for further 12 months. The extension may be
obtained by registering the product, filling a form available on the website: www.
skiddou.com.
6. The warranty is valid in the country of purchase.
7. The warranty of the manufacturer is non-transferable and may be used to make claims by
the first buyer only.
8. Identified faults shall be removed free of charge by the Guarantor during the warranty
period.
9. The customer (reporting a complaint) shall be obliged to report a complaint via the www.
skiddou.com website. The instructions for reporting a complaint and sending a faulty
product is available on the website.
element
Ride-on body with rear wheels
Handlebars
Fork with front wheels
Handlebars pad
Assembly pipe
quantity
1
1
1
1
1
9