Switching The Kettle Off; Descaling; Cleaning & Maintenance - Inventum CBW010 Mode D'emploi

Attention: never switch the kettle on without water.
If, for whatever reason, the kettle is switched on without water, the dry-boilprotection will automatically switch the kettle off. Put
the switch back up. In this case take the kettle from the base and let it cool down for several minutes. After that, refill the kettle and
switch it on again. Make sure that the lid is closed properly, if not the kettle will go on boiling and will not automatically switch off.
5

switching the kettle off

The kettle will automatically switch off when the water is boiled and the pilot lamp will switch off. If you want to boil the water again,
you must wait approx. 30 seconds before you switch it on again, so that the switch can cool down. The kettle can also be switched
off at any time with the switch. When you take the waterkettle off the base while boiling, it will switch off. When you place the
waterkettle back on the base, you must again wait approx. 30 seconds to let the switch cool down before you can switch it back on.
Attention! It may occur that you see condensation on the base. This is completely normal and has no consequences for the use of
the waterkettle.
6

descaling

Scale can form on the inside of the waterkettle. We advise to descale the waterkettle from time to time. Use a suitable
descalingproduct for waterkettles/ coffeemachines and follow the instructions.
You can also descale the waterkettle with lemonjuice. The acid in this juice will remove the scale. This natural method avoids the
use of chemicals. Fill the waterkettle half-full with warm water. Add the juice of half a lemon. Boil the water and leave it to cool for
half an hour. Throw away the boiled water and rinse the waterkettle to remove any remainders. Fill the waterkettle with fresh water
and boil it again. Throw away the water and rinse the kettle once more. Never clean the appliance with detergents. These products
can damage your waterkettle.
To remove the anti-scalefilter for cleaning, take the waterkettle of the base and let it cool down. Do not remove the anti-scalefilter
when the waterkettle is still warm and/or filled with water. Pull the anti-scalefilter straight back out of the spout and clean it with
warm water. Make sure while replacing the filter to place it correctly in the spout. Place the point of the anti-scale filter first and then
push the filter back in place.
Never place the anti-scalefilter loose in the waterkettle.
7
cleaning & maintenance
Clean the waterkettle on regular bases for continues performance. Never immerse the waterkettle, the base or the plug in water
or others liquids. Let the waterkettle cool off and always unplug the appliance before cleaning. Wipe the outside of the waterkettle
with a damp cloth and dry the kettle afterwards. Never use any abrasives!
13
English •